Eotech Target Pointer Illuminator Aiming Light Manual do Utilizador descarregar pdf (Página 31)

2-7

f. Attach the mounting rail to the bracket posts and

secure with rail mounting screws (2). Using a 3mm

hex head wrench, completely tighten the front screw

(closest to muzzle), then tighten the rear screw.

NOTE

Failure to fully tighten the Rail Grabber Bracket

and AN/PEQ-2A thumbscrew may cause zero

retention problems.

g. Position the AN/PEQ-2A on the mounting rail as

shown in Figure 2-4. Turn the thumbscrew

clockwise to tighten. Use a screwdriver or similar

tool in the slot of the thumbscrew to fully secure the

AN/PEQ-2A to the mounting rail.

h. Install the Remote Cable Switch in a convenient

location (see paragraph 2.5.3).

Figure 2-4 M16A2 Using M4/M16A2 Bracket Assembly

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 97 98

Sem comentários

Eotech Target Pointer Illuminator Aiming Light Manual do Utilizador Página 31